Item # DSAC100-12-12, Helical DS Series Aluminum Couplings On Japanese Products Corp.

Contact USA Rep Organizations In Your AreaSee List on the Contact US tab

Contact USA Inside SalesCatherine Topar
Ph: 203-334-7537
Fx: 203-334-7792
Email: ctopar@e-jpc.com

Product NavigatorSearch By Specification Search By Keyword Shop

Request Information

High torsional stiffness
Low radial loads
Parallel misalignment capability
Low inertia

The DS Series was designed for today's high performance motion control systems. This Series incor porates two helical beams in each of two separate HELI-CAL Flexures, combining greater end-to-end rotational accuracy with radial flexi bility in one design. Available only with integral clamp attachments, the DS Series provides the high torsional stiffness and low inertia necessary for positioning devices, servomore

Unit of Measure

Product Type	N/A Coupling
Series	N/A DSAC
Material	N/A 7075-T6 Aluminum Alloy
Finish	N/A Clear Anodize
Outside Diameter Designator	N/A 100
Outside Diameter (D)	N/A 1 in
Length (L)	N/A 1.50 in
Size (+0.002 in/-0.000 in)	N/A 0.375 in9.53 mm
Bore Designator	N/A 12
Momentary Dynamic Torque	N/A 25 lb·in
Torsional Rate	N/A 0.19
Inertia¹	N/A 0.35 x 10^-5 lb.in.sec²
Screw Size²	N/A 6 - 32
Seating Torque	N/A 19 lb·in
Center Line	N/A 0.15 in
Min. Size	N/A 0.250 in6.35 mm
Max. Size	N/A 0.394 in10.00 mm
Max. Bore Diameter	N/A 0.563 in14.31 mm
Bore Depth	N/A 0.38 in9.65 mm
Features	N/A High torsional stiffness Low radial loads Parallel misalignment capability Low inertia The DS Series was designed for today's high performance motion control systems. This Series incorporates two helical beams in each of two separate HEU-CAL Flexures, combining greater end-to-end rotational accuracy with radial flexibility in one design. Available only with integral clamp attachments, the DS Series provides the high torsional stiffness and low inertia necessary for positioning devices, servo motors and lead screws. The DS Series also provides you with substantial 0.010-inch parallel offset capability, reducing the need for high-precision alignment during assembly operations. It's your ticket to greater system accuracy and reliability. Available only in 7075-T6 aluminum.
Note	N/A Shaft misalignments: Angular 3 degrees Parallel Offset 0.010 in. Axial Motion: ±0.008 in. Manufacturing dimensional tolerances unless otherwise specified are: fraction ± 1/64 x.xx ± .01 in.