Contact USA Rep Organizations In Your AreaSee List on the Contact US tab
Contact USA Inside SalesCatherine Topar
Ph: 203-334-7537
Fx: 203-334-7792
Email: ctopar@e-jpc.com
Product NavigatorSearch By Specification Search By Keyword
Shop
  • High torsional stiffness
  • Low radial loads
  • Parallel misalignment capability
  • Low inertia
The DS Series was designed for today's high performance motion control systems. This Series incor porates two helical beams in each of two separate HELI-CAL Flexures, combining greater end-to-end rotational accuracy with radial flexi bility in one design. Available only with integral clamp attachments, the DS Series provides the high torsional stiffness and low inertia necessary for positioning devices, servo motors and lead screws.

The DS Series also provides you with substantial .010-inch parallel offset capability, reducing the need for high-precision alignment during assembly operations. It's your ticket to greater system accuracy and reliability. Available only in 7075-T6 aluminum.
Unit of Measure

Product Type

N/A Coupling

Series

N/A DSAC

Material

N/A 7075-T6 Aluminum Alloy

Finish

N/A Clear Anodize

Outside Diameter Designator

N/A 150

Outside Diameter (D)

N/A 1 1/2 in

Length (L)

N/A 2.25 in

Size (+0.002 in/-0.000 in)

N/A 0.625 in15.88 mm

Bore Designator

N/A 20

Momentary Dynamic Torque

N/A 94 lb·in

Torsional Rate

N/A 0.062
Inertia1 N/A 2.7 x 10-5 lb.in.sec2
Screw Size2 N/A 10 - 24

Seating Torque

N/A 50 lb·in

Center Line

N/A 0.22 in

Min. Size

N/A 0.375 in9.53 mm

Max. Size

N/A 0.630 in16.00 mm

Max. Bore Diameter

N/A 0.908 in23.07 mm

Bore Depth

N/A 0.57 in14.48 mm

Features

N/A
  • High torsional stiffness
  • Low radial loads
  • Parallel misalignment capability
  • Low inertia
The DS Series was designed for today's high performance motion control systems. This Series incorporates two helical beams in each of two separate HEU-CAL Flexures, combining greater end-to-end rotational accuracy with radial flexibility in one design. Available only with integral clamp attachments, the DS Series provides the high torsional stiffness and low inertia necessary for positioning devices, servo motors and lead screws.
The DS Series also provides you with substantial 0.010-inch parallel offset capability, reducing the need for high-precision alignment during assembly operations. It's your ticket to greater system accuracy and reliability. Available only in 7075-T6 aluminum.

Note

N/A
  1. Shaft misalignments:
    Angular 3 degrees
    Parallel Offset 0.010 in.
    Axial Motion: ±0.008 in.
  2. Manufacturing dimensional tolerances unless otherwise specified are:
    fraction ± 1/64
    x.xx ± .01 in.


Attachment Methods

Equal diameter shafts

Internal Configuration

Ordering Information-DS Series

Unequal Diameter Shaft

  • 1 Inertia is based on smallest standard bore diameter.
  • 2 Metric fasteners available on request.