Item # DMN37J6HFPB-6DG18F, DMN37 6DGF Series DC Brush Motors with Continuous Operation On Japanese Products Corp.

Long-life : Intermittent operation over 1 million cycles with optimized brush design.
Continuous operating life of 3000 hours.
High output: High heat dissipation and heat resistance achieves higher output
High strength : High radial load capacity due to robust construction, large diameter output shaft and ball bearings
Low noise and increased insulation due to new resin brush holders.
Large selection of gear heads and reduction ratios are available to meet all needs.
Also available with magnetic revolution sensor and noise filter.

Unit of Measure

Specifications | Dimensions | Additional Information | Customize

Product Type	N/A DC Brush Motor
Series	N/A DMN37
Frame Size	N/A 61 x 61 mm2.402 x 2.402 in
Gear Ratio	N/A 18
Rated Torque	N/A 72.3 oz·in0.51 N·m
Speed	N/A 200 r/min
Voltage	N/A 24 V
L	N/A 108.7 mm4.280 in
Weight	N/A 640 g1.4 lb
Note	N/A 6DG gearbox are available with either 4.5 mm diameter mounting holes or M4 x 6mm tapped holes. Gearboxes with 4.5 mm diameter mounting holes are available from stock. When ordering, please write the motor model and gearbox model numbers separately, as in the following example: DMN37B6HFP_ (Pinion shaft motor) 6DG( )F(Gearbox) Gearboxes with M4 x 6 mm tapped mounting holes are available on request. When ordering, please write the combine motor and gearbox model, as in the following example : DMN37B6H( )F_ Enter the required reduction ratio in the ( ) Enter ther required voltage A or B in the _