Type |
N/A Palm Mini Plus J-Book Type Motors 61X61 |
Product Type |
N/A DC Motor |
Series |
N/A FHD |
Motor Frame Size |
N/A 61 x 61 mm2.4 x 2.4 in |
Number of Poles |
N/A 14 |
Shaft Specification |
N/A Pinion Shaft Type |
Rated Voltage |
N/A 24 V |
Rated Voltage |
N/A 24 V |
Rated Output |
N/A 20 W |
Rated Torque |
N/A 98 mN·m14 oz·in |
Rated Speed |
N/A 2000 r/min |
Speed Control Range |
N/A 200 to 2500 r/min |
Max. Instantaneous Torque (in 5 sec.) |
N/A 150 mN·m (2000 r/min) 21 oz·in (2000 r/min) |
Speed Setting Method |
N/A (1) Speed setting by external speed setter (Sold separately: model code Q-R10KB) (2) Speed setting by external voltage supply 0~10V |
Speed Setting |
N/A 300±5 % |
Speed Variation (Against Load ±1%) |
N/A 0~rated torque at rated voltage and speed |
Speed Variation (Against Voltage ±1%) |
N/A Rated voltage ± 10 % at rated speed, no load |
Input Signal |
N/A H : Open collector L : GND (0~0.8V) Run, Brake, F/R IN, Alarm RST (Only 60W) |
Output Signal |
N/A 10 mA. Max. Alarm, Speed Out (Pulse Output), F/R Out Open Collector Output DC 30 V Max. |
Speed Pulse (Pulse/Revolution) |
N/A 42 |
Max. Average Current Rated |
N/A 1.8 A |
Max. Peak Current Rated |
N/A 9 A |
Operation Temperature |
N/A 0~40ºC (no condensation) continuous duty. The motor flange surface temp. must be 80ºC Max. (Ambient temperature 40ºC without heat sink) |
Motor Dielectric Strength |
N/A Withstand for 1 min. under AC500V 50Hz (Between case and coil) |
Motor Insulation Resistance |
N/A 10 MO MIN. (20 W, 40 W) 100 MO; MIN. (60 W) (Between case and coil by DC 500 V tester) |
Note |
N/A Minimum Order Quantity May Apply |
Max. Instantaneous Torque at 2000 r/min (in 5 sec.) |
N/A 150 mN·m21 oz·in |
Speed Variation (Against Temperature ±3%) |
N/A 20 ±20ºC at rated voltage and speed, no load |
Protection Functions |
N/A
Over load protection When an exceeding torque than rated is applied to motor for more than about 5 sec., Stop motor and outputs "L" from "ALARM" (20W, 40W) or "ALARM OUT" (60W). To release alarm : Palm Mini PLUS type: Disconnect power supply for more than 1min J-Book type: Input "L" to "ALARM RST" for more than 1sec. Do not measure/judge by this operation whether the motor is overloaded or not. |
Rated Power |
N/A 20 W |
Peak Current |
N/A 9 A |
