Japanese Products Corp.
120 Fiske St., Fairfield, CT 06825-5524 US
Phone:203.334.7537 • Fax:203.334.7792
E-Mail: info@e-jpc.com • Web site: www.e-jpc.com
All Categories > Permanent Magnet DC Motors > DMN Series Motors > DMN 29 Series Motors > DMN29 6DG Series DC Brush Motors with Continuous Operation > Item # DMN29B6HPA-6DG9  


Item # DMN29B6HPA-6DG9, DMN29 6DG Series DC Brush Motors with Continuous Operation

  • Long-life : Intermittent operation over 1 million cycles with optimized brush design.
  • Continuous operating life of 3000 hours.
  • High output: High heat dissipation and heat resistance achieves higher output
  • High strength : High radial load capacity due to robust construction, large diameter output shaft and ball bearings
  • Low noise and increased insulation due to new resin brush holders.
  • Large selection of gear heads and reduction ratios are available to meet all needs.
  • Also available with magnetic revolution sensor and noise filter.



 Specifications 

Product Type
DC Brush Motor

Series
DMN29

Frame Size
61 x 61 mm
1.949 in

Gear Ratio
9

Rated Torque
8.07 oz·in
0.057 N·m

Speed
411 r/min

Voltage (DC)
12 V

Weight
350 g
0.77 lb

Note
6DG gearbox are available with either 4.5 mm diameter mounting holes or M4 x 6mm tapped holes.
  • Gearboxes with 4.5 mm diameter mounting holes are available from stock.
    When ordering, please write the motor model and gearbox model numbers separately, as in the following example:
    DMN29B6HP? (Pinion shaft motor)
    6DG_(Gearbox)
  • Gearboxes with M4 x 6 mm tapped mounting holes are available on request.
    When ordering, please write the combine motor and gearbox model, as in the following example : DMN29B6H( )_
  • Enter the required reduction ration in ( )
  • Enter the required voltage A or B in the _
Rotation of gearbox shaft is in reverse of rotation of motor.



Print Back