Item # DMN37S6HPA-6DG5, DMN37 6DG Series DC Brush Motors with Continuous Operation On Japanese Products Corp.


	Item # DMN37S6HPA-6DG5, DMN37 6DG Series DC Brush Motors with Continuous Operation

Long-life : Intermittent operation over 1 million cycles with optimized brush design.
Continuous operating life of 3000 hours.
High output: High heat dissipation and heat resistance achieves higher output
High strength : High radial load capacity due to robust construction, large diameter output shaft and ball bearings
Low noise and increased insulation due to new resin brush holders.
Large selection of gear heads and reduction ratios are available to meet all needs.
Also available with magnetic revolution sensor and noise filter.

Unit of Measure: Imperial Metric Both

Specifications

Dimensions

Additional Information

Customize

Product Type		DC Brush Motor

Series		DMN37

Frame Size		61 x 61 mm 2.409 x 2.409 in

Gear Ratio		5

Rated Torque		5.56 oz·in 0.039 N·m

Speed		900 r/min

Voltage		12 V

L		75.7 mm 2.980 in

Weight		390 g 0.86 lb

Note		6DG gearbox are available with either 4.5 mm diameter mounting holes or M4 x 6mm tapped holes. Gearboxes with 4.5 mm diameter mounting holes are available from stock. When ordering, please write the motor model and gearbox model numbers separately, as in the following example: DMN37B6HP? (Pinion shaft motor) 6DG>(Gearbox) Gearboxes with M4 x 6 mm tapped mounting holes are available on request. When ordering, please write the combine motor and gearbox model, as in the following example : DMN37B6H( )_ Enter the required reduction ration in ( ) Enter the required voltage A or B in the _ Rotation of gearbox shaft is in reverse of rotation of motor.

Item # DMN37S6HPA-6DG5, DMN37 6DG Series DC Brush Motors with Continuous Operation